Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Hello. I have created a model that's finished with its texturing. When i use the joint tool all my textures seem to turn white or go into the wrong places whenever i try to set a joint. Is there any real reason this is happening?
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off