Make trim edje a line.
Hi guys:
I would like to know if i can make a trim edge a line from a surface that has been proyected from a line (2 curved surface result).
The thing is that i am trying to loft between two of these surfaces mentioned and all i can select are little pieces of trim edje wich i can loft but i cannot loft them all together cause i dont get the result (hell of a job).
Something like this:
[IMG] [/IMG]
I thought if i can obtain the curve i could loft easily. If anybody can solve this easily please tell. I am a beginner.
Thanks very much in advance.
Last edited by jose3; 25-05-2003 at 03:54 AM.