Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Hi i'm doing a Ik on the arm of my modell but i get a strang flip of the hand i will now tell what i do.
I do a IK handel with stickey off and do it from arm to foreArmRoll
Then i select ForArmRoll and press f
Then i select the effector i get from pressing f and move the pivot of the effector to Hand-joint.
Then for the IK that i didi i go in to atrbute and set stickines to Stickey
[And now the arm flips wierd do you know why?]
Hello
Thanks for your wisits at this problem but i found the problem
I put the Ik on the wrong joint so it was wrong when i put the effector on the right spot but the ik were not there it was supose to be so it messt up.
So the problem vas that i was little misstake i did but it is solved now
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off